The EDS Phillips Screwdriver at 3.5 x 120mm fits neatly into the smaller screw heads used on many RC builds, letting you perform delicate assembly and maintenance tasks with control. It gives a consistent bite on Phillips screws to reduce cam-out.
This driver uses EDS spring steel for the blade, providing good torsional strength and resistance to wear. The choice of steel helps the tool remain accurate even after repeated tightening and loosening.
From servo mounts to chassis hardware, the length and shaft diameter make this screwdriver handy across a range of RC platforms. Its dimensions match the common fasteners found in typical 1/10 scale models.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
