EDS 140158 Phillips Driver 5.8 X 120mm - Workshop Essential  [EDS-140158]

EDS 140158 - Phillips Screwdriver 5.8 X 120mm
Price:
NZD$17.76
Brand:
EDS
Model:
EDS-140158
Condition:
Brand New
Write a review

Workshop-Grade Phillips Screwdriver

The EDS 140158 Phillips screwdriver is a neat addition to any RC toolkit, offering a 5.8mm head and a 120mm length for reach and control. It is intended for the small fastening jobs that come up during model assembly and set up.

Spring Steel Reliability

Constructed from EDS spring steel, this driver resists bending and keeps its tip profile under normal workshop stresses. That durability helps preserve tip engagement and reduces the chance of rounding screw heads.

Precision Where It Counts

The tool is well suited to precise tasks such as tightening servo hardware and securing electronics in cramped bays. Its Phillips geometry works with most standard screws used on RC models.

Can I use this on aluminium and steel fasteners?

Yes. The EDS 140158 handles machine screws in aluminium or steel components, though matching tip size and using correct torque is important to avoid damage.

Does the screwdriver tip need replacing over time?

With normal hobby use the tip lasts a long time, but heavy or improper use can wear it. Replace if you notice rounding or poor fit with screws.

Is the 120mm length useful for tight assemblies?

The 120mm shaft gives extra reach for recessed screws while still being slim enough to access tight spaces commonly found in RC builds.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved