EDS 150279-L 5/16'' (7.938MM) Nut Driver Lightweight 100mm  [EDS-150279-L]

Price:
NZD$22.45
Brand:
EDS
Model:
EDS-150279-L
Condition:
Brand New
Write a review

Bench-Friendly Nut Driver from EDS

The EDS nut driver, sized 5/16'' (7.938mm) x 100mm, is built for routine RC maintenance and tuning. Its low weight makes it comfortable for repeated use while keeping the tip aligned for precise turns.

Light Build, Practical Strength

Designed to be both sturdy and light, this driver provides a useful mix of durability and nimble handling. It suits small adjustments, part swaps, and on-the-fly repairs without wearing your hands.

Fits Many Common RC Nuts

The 5/16'' diameter covers a wide range of nuts commonly used in RC kits. It delivers the control needed for tightening or releasing fasteners during setup and maintenance.

Is this tool suitable for chassis work?

Yes, the size and length make it useful for many chassis fasteners, especially where a slim, precise driver is preferable to bulkier tools.

Will the handle cause hand fatigue?

The lightweight construction reduces strain compared with heavier drivers, helping maintain comfort during longer builds or setup sessions.

Can I use it for wheel nuts?

It is suitable for many wheel and body fasteners that accept a 5/16'' driver, but always check the specific nut type and depth before use.

Should I pair this with other sizes?

Yes, keeping a set of common sizes alongside this driver lets you tackle a wider range of fasteners without improvising with unsuitable tools.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved