EDS 151144 4.5mm Metric Nut Driver Tip - Workshop Ready  [EDS-151144]

EDS 151144 - Nut Driver 4.5mm X 60mm Tip Only - Metric
Price:
NZD$9.90
Brand:
EDS
Model:
EDS-151144
Condition:
Brand New
Write a review

Tight Fit and Consistent Control

RC tuners will appreciate the EDS 151144 for its 4.5mm metric profile and dependable seating on small nuts. It helps deliver neat, repeatable results during setup and trackside checks.

Long Lasting Service Life

The EDS 151144 tip is produced to resist routine wear and to maintain its shape through many service cycles. It pairs with various EDS handles so you can integrate it into your existing toolkit.

Useful for Setup and Small Upgrades

From adjusting wheel hardware to tightening linkages, the EDS 151144 4.5mm tip gives the precise engagement needed for common RC tasks. Its metric sizing matches many standard fittings used across model types.

Can I use this tip with my existing EDS bit holder?

Yes, the EDS 151144 is designed to work with most EDS bit holders and handle systems, but double check the holder type to be sure of a snug fit.

How often should I replace the tip?

Replacement depends on usage; inspect the tip for rounding or poor engagement and swap it when you notice reduced fit or slipping.

Is this suitable for assembly and race prep?

Yes, the 4.5mm EDS 151144 tip is handy for assembly tasks and routine race prep where small metric fasteners are used.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved