EDS 161125 2.5mm Suspension Arm Reamer 120mm - Hobby Workshop [EDS-161125]

Price:

NZD$11.20

Brand:

EDS

Model:

EDS-161125

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Fine Bore Reamer for RC Arms

Hobbyists who like tidy builds will find the EDS 161125 - Precision Arm Reamer useful for smoothing and sizing suspension arm holes. Its 2.5mm diameter and 120mm reach make it straightforward to access tight areas without straining the tool.

Tune Suspension Holes with Care

The EDS 161125 helps align and clear bores so pins and pivots move freely, improving consistency across repairs and upgrades. Use steady, measured strokes to avoid overcutting and keep parts fitting as intended.

Will this reamer fit all RC arm types?

It is best suited to arms with holes sized for a 2.5mm bore. Many common 1/10 and 1/8 scale parts match this size, but always check before use.

Is a powered drill safe to use with this tool?

Hand use is recommended for control, but if using a drill keep speeds low and use light pressure to avoid removing too much material or overheating the part.

Can I ream worn holes to extend part life?

You can carefully true up slightly worn bores to improve fit, but deep wear or damaged parts should be replaced rather than overworked.

How many passes should I take when reaming?

Make several light passes, checking fit often. Small increments give more control than trying to remove too much in one go.

Hot Brands