EDS 161130 Suspension Arm Reamer 3.0mm x 120mm  [EDS-161130]

EDS 161130 - Arm Reamer 3.0 X 120mm
Price:
NZD$11.20
Brand:
EDS
Model:
EDS-161130
Condition:
Brand New
Write a review

Fine Tune Suspension Holes

The EDS 161130 Arm Reamer offers controlled material removal to give suspension pivots a snug, low-friction fit. Sized at 3.0mm and 120mm long, it reaches through common arm layouts to tidy up worn or oversized holes. It is aimed at enthusiasts who prefer hands-on setup work and careful component maintenance.

Why Pick the EDS 161130?

This tool delivers steady, repeatable reaming for better steering and suspension response. Its 3.0mm profile and long reach make it handy for both routine trimming and late-stage adjustments when dialing in cornering behaviour.

Is the 3.0mm size standard for most hinge pins?

Many hinge pins and suspension pivots use 3.0mm or similar sizes, so the EDS 161130 is a useful match for common setups, but always check the component spec first.

Can I ream metal components with this tool?

It is primarily intended for softer materials like plastics and some light alloys; reaming hardened metal may dull the cutting edge quickly, so proceed with caution.

What technique gives the best results?

Hold the arm steady, start the reamer by hand to establish alignment, then apply light, even pressure while turning to avoid wobble and oversized holes.

How long is the shaft on the EDS 161130?

The tool has a 120mm length, which helps reach recessed pivot points and gives good leverage for controlled trimming.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved