EDS 181002 20mm Droop Gauge Blocks for 1/8 and 1/10 RC Models  [EDS-181002]

Fine Tuning with EDS 181002 Blocks

For racers and club drivers who want repeatable setup numbers, the EDS 181002 Chassis Droop Gauge Blocks make droop checks quick and accurate. They are tailored to 1/8 and 1/10 scale vehicles where precise suspension travel matters.

Why droop matters for grip and balance

Droop is the amount the suspension extends when the car is raised and it influences how weight transfers mid corner and on acceleration. Setting droop consistently helps deliver predictable grip from lap to lap.

Practical use and fitment

The 20mm thickness works well with a wide range of 1/8 and 1/10 buggies and touring cars. Place the gauge under the chassis at the standard points, then tweak shock lengths or spring preload until the chassis contacts the block at your target setting.