EDS-120130-L EDS 3.0 x 120mm Ball End Allen Wrench Compact  [EDS-120130-L]

Price:
NZD$19.54
Brand:
EDS
Model:
EDS-120130-L
Condition:
Brand New
Write a review

Fine tuning with the EDS-120130-L ball wrench

The EDS-120130-L Ball Allen Wrench from EDS is crafted for model tuners who demand accurate control. The 3.0 x 120mm profile delivers a lightweight tool that still stands up to routine adjustment work.

Designed for comfortable toolwork

Its reduced mass makes it easier to handle during intricate adjustments, letting you work longer on small parts without hand fatigue. It is ideal for setup checks and precise alignment tasks.

Exactly the metric size you need

Built for metric fasteners, the 3.0mm tip fits many standard screws used in RC kits. Use it for securing electronics mounts, tightening linkages, and trimming component clearances.

Ball end for angled engagement

The rounded tip allows you to access screws from off-center angles, which is handy when panels or other parts block a straight approach on tight assemblies.

Can I use this on small aircraft models as well?

Yes. Any model that uses 3.0mm metric hex screws can benefit from the EDS-120130-L, including small planes and helicopters for control horn and servo link adjustments.

Does the ball end wear faster than a straight tip?

Under normal hobby use the ball end holds up well, but repeated high torque can round the profile. Use it mainly where angled access is needed and save straight keys for heavy torque.

Is this wrench compatible with anodised screws?

Yes, it will work with anodised screws. Take care to avoid slipping and apply steady pressure to prevent marking the screw head or the alloy finish.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved