EDS-140158-L EDS 5.8mm Phillips Screwdriver 120mm Precision  [EDS-140158-L]

Price:
NZD$21.79
Brand:
EDS
Model:
EDS-140158-L
Condition:
Brand New
Write a review

Balanced Tool for Precision Work

The EDS-140158-L Phillips Screwdriver by EDS is tailored for model builders who prioritise steady control and compact weight in their toolkit. It blends a slim profile with dependable tip strength for everyday RC tasks.

Size, Reach and Feel

At 5.8mm across the tip and 120mm overall length, the EDS-140158-L provides reach into tight bays while remaining nimble for delicate adjustments. Its light construction reduces fatigue during extended building sessions.

Typical RC Tasks

This screwdriver suits common Phillips screws used on frames, servo mounts and small fixtures. The accurate tip engagement helps protect screw heads and keeps parts secure during setup and maintenance.

Can I use this for electronics inside models?

Yes, the fine tip and controlled length make it suitable for small electronics screws, but avoid excessive torque near delicate components.

Does the handle offer good grip?

The lightweight handle balances grip and comfort; for long sessions consider pairing it with a non slip mat or gloves if needed.

Is the tip replaceable?

The tool is built as a single piece for stability. If you need replaceable bits consider a dedicated bit driver instead.

How should I store this screwdriver?

Keep it in a padded case or tool roll to protect the tip and prevent corrosion; wipe the tip after use to prolong life.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved