Element Enduro Front Bumper Mount (Aluminum) JR-EE09-GU by Jazrider  [JR-EE09-GU]

This machined aluminum front bumper mount was created as an RC-scale replacement for Element Enduro trail trucks. Supplied in a gun metal finish, the bracket gives a stronger mounting point than molded plastic and helps keep the bumper aligned with the chassis under load.

From a setup perspective the mount reduces front-end flex and supplies a repeatable hardpoint that alters crash dynamics. Because it bolts directly to the chassis, impact forces route differently into the front assembly, so consider this when adjusting bumper height, protection or skid clearance.

Installation is straightforward: the mount bolts into the Element Enduro front mounting locations using the original fasteners or suitable replacements. After fitting, verify servo horn travel and suspension arc for any contact, and use appropriate torque to protect threads and parts. Check and retighten screws after initial running sessions.

Routine checks are recommended: inspect screws for loosening, look for bends or deformation after heavy impacts, and ensure the gun metal surface is free from sharp burrs that might damage cables or parts. The component is intended as a hobby-grade structural upgrade for compatible Element Enduro models.