Element Enduro Trail Truck Aluminium Front Bumper Brace JR-EE09-S by Jazrider  [JR-EE09-S]

Element Enduro Aluminum Front Bumper Mount (Silver)
Price:
NZD$16.45
Brand:
JAZRIDER
Model:
JR-EE09-S
Condition:
Brand New
Write a review

Front bumper brace made for Element Enduro

This aluminium front bumper mount replaces the stock plastic component on the Element Enduro Trail Truck chassis. CNC-machined for rigidity, the part lowers flex and helps hold the bumper in line during slow-speed technical sections.

Fitment is intended to use the Enduro's existing bumper mounting points for a straightforward swap. Standard hex drivers are sufficient and the mount is meant to accept the vehicle's original fasteners and bumper hardware where applicable.

As a tuning item the brace increases front-end stiffness and stabilises bumper position after impacts, which improves consistency on technical trails and reduces repeated stress on plastic mounting tabs without changing suspension geometry.

What tools do I need to fit this aluminium mount?

Basic hex drivers cover the installation; no specialised tools are required. Remove the original mount and reuse compatible fasteners when possible.

Will any trimming be required for clearance with other parts?

The brace is designed for direct fitment to the Enduro chassis. In most cases no trimming is necessary, though verify clearance if you run an unusually tall or wide aftermarket bumper.

Is this part better suited to hard crawling or casual trail runs?

It is primarily aimed at scale trail driving and technical slow-speed sections where improved alignment and reduced plastic wear are the priority rather than aggressive competition crawling.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved