EMO 63T M1.0 Spur Gear CRXXL063TS for CROSSRC EMO Chassis by GPM  [CRXXL063TS]

CROSSRC EMO 40CR Steel Main Gear 63T (M1.0) - GPM CRXXL063TS
Price:
NZD$28.32
Brand:
GPM
Model:
CRXXL063TS
GTIN:
4894538412277
Condition:
Brand New
Write a review

Hardened 63T M1.0 spur for EMO series

This 63-tooth spur is produced in hardened 40Cr steel and matches the metric 1.0 pitch used on CROSSRC EMO platforms. It is intended as a direct replacement or upgrade to improve tooth life under load for 1/5 and 1/6 scale applications.

During installation verify pinion compatibility with M1.0 pitch and set gear mesh carefully. Proper alignment of bearings and shafts will help reduce premature wear and running noise. Handle hardened components with caution to prevent chipping while fitting.

Packing includes

  • Main Gear 63T M1.0 - 1pcs

Compatible Models

  • CROSSRC 1/6 EMO XXL 6X6
  • CROSSRC 1/6 EMO XX 4X4
  • CROSSRC 1/5 EMO XX2 4X4
  • CROSSRC 1/5 EMO XXL2 6X6

A material-led 63T M1.0 replacement for EMO gearboxes that balances strength and consistent gear engagement for long trail sessions and scale running.

Will this fit my EMO model?

It fits CROSSRC EMO models listed in the compatibility box that use a 63T M1.0 spur; confirm your gearbox uses a metric 1.0 pitch.

Is any special tooling required?

Basic RC tools are sufficient: hex drivers, shim set and a feeler for mesh. No special machining is required for direct replacement fitment.

How should I inspect the gear after running?

Check tooth faces for rounding or chips and inspect bearings for play; replace if teeth show heavy wear or deformation.

Can I polish the teeth to reduce noise?

Light deburring with a fine file can help, but avoid removing significant material which would change mesh dimensions.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved