E-Station Compatible Multi-LiPo Balance Hub for PolyQuest and Hyperio - CSEAC143 by Bantam  [CSEAC143]

BANTAM MULTI-LIPO BALANCE ADAPTOR BOARD (POLYQUEST/HYPERIO) FOR E-STATION BC5/BC6/BC6-10/PB6 #EAC143
Price:
NZD$9.26
Brand:
Bantam
Model:
CSEAC143
Condition:
Brand New
Write a review

Compact multi-LiPo balance interface

The Bantam CSEAC143 adaptor converts PolyQuest and Hyperio style balance leads into a form that plugs into charger balance sockets found on E-Station BC5, BC6, BC6-10 and PB6 units. It serves as a routing point to let you manage several LiPo packs from one balance port without repeated connector swaps.

Fit the pack's balance lead into the matching PolyQuest or Hyperio jack on the board, then connect the board to the charger's balance input. Confirm the battery cell count and visually check polarity before powering up the charger, and use the adaptor only as a balance harness, not as a replacement for correct charger configuration.

In workshop use the adaptor tidies multiple balance leads and reduces wear on charger ports while maintaining solid contact for safe charging and balancing operations.

Works with these plugs and chargers

  • PolyQuest balance plugs
  • Hyperio balance plugs
  • E-Station BC5
  • E-Station BC6
  • E-Station BC6-10
  • PB6

Are there any polarity or cell-count checks I should do before charging?

Always confirm the pack cell count on your charger matches the battery and visually verify connector orientation before applying power. The adaptor does not change cell wiring, so charger settings must be correct.

Will using the adaptor affect balance accuracy?

The board uses low-loss contacts to preserve balance accuracy, but proper connector seating and clean contacts are important to maintain consistent readings during balance cycles.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved