Tamiya F103GT Graphite Rear Upper Deck Plate - F103GT-21/SG by 3Racing  [F103GT-21/SG]

Tamiya F103GT SSG Graphite Rear Upper Deck Plate - 3RACING F103GT-21/SG
Price:
NZD$24.34
Brand:
3Racing
Model:
F103GT-21/SG
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Product overview

This is a graphite rear upper deck plate created for the Tamiya F103GT chassis, listed as F103GT-21/SG. It is an aftermarket hop-up aimed at altering rear torsional stiffness to influence handling and overall balance on 1/10 GT tracks.

The part replaces the stock rear upper deck using the existing F103GT mounting locations, so installation stays simple with standard screws. Graphite's greater rigidity versus typical plastic helps limit flex under cornering loads while preserving a low mass suitable for performance RC cars.

Fit this plate when you want to pursue chassis tuning through structural changes rather than suspension swaps. You should notice adjustments to rear grip and transient feel as chassis stiffness shifts load behaviour during turns and acceleration.

Is the F103GT-21/SG compatible with other F103 variants?

The plate is specifically shaped for the F103GT rear upper deck mounting scheme; compatibility with other F103 variants depends on their rear deck geometry. Verify mounting hole pattern before fitting.

Any torque recommendations for the mounting screws?

Use moderate torque to secure the plate so the screws are snug but not overly tight; over-tightening can crack composite parts or strip threads.

Should I change other chassis parts when fitting this deck?

Not necessarily. Start with the graphite plate alone and evaluate handling; you can then adjust springs, anti-roll bars, or toe to fine tune balance.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved