Factory Pro FP-M-AC3110SV 7075 Alu Spacer 3x9x1.0mm Silver Pack of 8  [FP-M-AC3110SV]

Price:
NZD$11.89
Brand:
Factory Pro
Model:
FP-M-AC3110SV
Condition:
Brand New
Write a review

Dial in setups with Factory Pro FP-M-AC3110SV

These 3x9x1.0mm Factory Pro 7075 aluminum spacers are a compact way to refine your model geometry. The silver eight-pack gives you repeatable shims for small adjustments on suspension or driveline components.

Material and measurement clarity

Forged from 7075 aluminum, the shims are thin yet stiff, and the 1.0mm thickness helps you achieve exact clearances without adding unnecessary weight. They suit fine tuning where millimetre accuracy matters.

Where they slot in

Use them for axle spacing, link shimming or anywhere a small, consistent gap is required. The universal 3x9mm bore and outer dimensions make them practical across a wide range of RC models.

Are these shims suitable for tuning steering geometry?

Yes. The consistent 1.0mm thickness makes them useful for small steering or toe-in adjustments when you need precise spacing.

Will they corrode in coastal conditions?

Aluminum is prone to surface oxidation over time; rinsing salt off after salty runs and drying parts helps limit corrosion. For heavy salt exposure consider additional coatings.

Can I stack multiple spacers for thicker shims?

You can stack several to build up thickness, but check that stacked shims sit flush and that fasteners still apply even pressure to avoid deformation.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved