Factory Pro Aluminum 7075 Red Spacer 3x9x3.0mm (8pcs) - Workshop Essentials  [FP-M-AC3130RD]

Price:
NZD$11.73
Brand:
Factory Pro
Model:
FP-M-AC3130RD
Condition:
Brand New
Write a review

Precision Shims for Tuners

The Factory Pro 7075 Aluminum Spacer pack, sized 3x9x3.0mm, is built for accurate spacing tasks in RC projects. These aluminium spacers use 7075 alloy for superior tensile strength and come in a red anodised finish that resists wear while keeping parts tidy.

Performance Advantages

These spacers are useful for correcting play and ensuring precise fitment between mating parts. Whether trimming clearance in drivetrains or fine-tuning suspension geometry, they provide consistent spacing without adding bulk. The alloy choice keeps weight down while retaining stiffness for spirited running.

Vehicle Fit and Scenarios

Compatible with a wide variety of components, these spacers suit most 1/10 scale cars and common upgrade kits. They are a handy item for hobbyists who frequently swap parts or experiment with setup changes.

Can I stack multiple spacers to achieve different thicknesses?

Yes, you can stack them to increase spacing, but ensure stacked assemblies remain secure and do not introduce play. Use correct fasteners and check clearance after stacking.

Do these spacers fit common bearing sizes?

They are designed to work with standard 3mm shafts and 9mm outer clearances; confirm bore and outer diameters on your bearings or hubs before installing.

Are aluminium spacers better than plastic for upgrades?

Aluminium spacers offer higher strength and longevity compared to plastic, making them preferable where stiffness and repeatable spacing matter. They may be heavier than the lightest plastics but perform better under load.

How should I check fit before racing?

Assemble parts on the bench, verify clearances and rotational freedom, then perform a short test run to confirm there is no binding or unwanted contact.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved