Factory Pro FP-A-MT0035 Masking Tape 35mm x 50m Precision Edge  [FP-A-MT0035]

Price:
NZD$20.78
Brand:
Factory Pro
Model:
FP-A-MT0035
Condition:
Brand New
Write a review

Tape for Accurate RC Model Painting

Factory Pro FP-A-MT0035 masking tape fits RC hobbyists aiming for neat paint separation. The 35mm width and 50m length make it suitable for covering panels while preserving adjacent finishes during painting.

Ideal Width for Panel Work

At 35mm, the tape covers medium areas without sacrificing accuracy, handy when masking doors, wings or body sections on 1/10 scale cars and small aircraft.

Good Adhesion with Controlled Release

Factory Pro manufactures this tape to stick reliably to common modelling materials and to help limit paint bleed. It is best used as a single application to guarantee consistent performance across a job.

Can I mask curved surfaces with this tape?

Yes, the tape flexes enough for mild curves. For tight curves divide strips into shorter pieces and press down progressively.

Will the adhesive lift underlying paint?

When applied and removed correctly it should not lift fully cured paint. Test on a scrap or hidden area first for delicate finishes.

Is the roll suitable for long projects?

The 50m length is convenient for multiple models or larger builds, reducing the need to change rolls mid project.

How do I avoid adhesive residue?

Remove tape slowly and at a low angle. If residue appears, a gentle solvent like isopropyl alcohol cleans the area without harming most paints.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved