Factory Pro FP-A-SS0710 Fine Adjustment Shim Kit 7x10mm 0.1 0.2 0.3mm  [FP-A-SS0710]

Price:
NZD$11.72
Brand:
Factory Pro
Model:
FP-A-SS0710
Condition:
Brand New
Write a review

Precision Adjustment Kit - Factory Pro FP-A-SS0710

The Factory Pro FP-A-SS0710 kit contains thirty 7x10mm shims in three sizes: 0.1mm, 0.2mm and 0.3mm. These small washers are handy when you are refining suspension geometry or gear engagement on scale RC builds.

Where to Use These Shims

They are suitable for fine spacing tasks such as trimming diff shims, correcting gear mesh or taking up slack in linkages. The multiple thicknesses make experimenting with setup easier at the bench.

Workshop Practices for Consistent Results

Keep a labelled organiser for each thickness and note any stack combinations you try. Small, repeatable changes make it simple to compare handling differences after a test run.

Are these shims suitable for gearbox spacing?

Yes, the 7x10mm size fits many gearbox applications where thin shims are needed to set correct gear mesh or bearing clearance. Verify the bore and outer size first.

Can I stack different thicknesses to get in-between values?

Stacking is a common method to reach custom gap values. For example, two 0.1mm shims equal 0.2mm, and a 0.1mm plus a 0.2mm gives 0.3mm.

Do I need special tools to fit these shims?

Basic hand tools and a pair of calipers are usually enough. Tweezers or a small pick help place thin shims without bending them.

How should I store leftover shims?

Keep them in a labelled compartment box or sealed bag to avoid loss and to quickly grab the thickness you need during setup changes.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved