Factory Pro FP-B-CB1005(8) Ceramic Ball Set 5x10x4mm - 8 Pack  [FP-B-CB1005(8)]

Price:
NZD$72.62
Brand:
Factory Pro
Model:
FP-B-CB1005(8)
Condition:
Brand New
Write a review

Upgrade to Ceramic Bearings

Hobbyists seeking reduced rolling resistance will find the Factory Pro FP-B-CB1005(8) Ceramic Ball Bearings a practical upgrade. These 5x10x4mm bearings are compatible with many RC car and buggy assemblies and help keep components turning freely.

Why Go Ceramic

Ceramic balls run cooler and wear slower than conventional steel, which can translate to quieter operation and more consistent performance over time. The set of eight provides spares for common pivot and wheel positions.

Quick Installation Notes

Remove old grease and dirt before fitting, and press bearings squarely into their housings to avoid misalignment. Light lubrication after installation helps seal out contaminants and improves initial break-in.

Which parts typically use 5x10x4mm bearings?

This size is common in wheel hubs, differential carriers, and some gearbox shafts on smaller scale RC cars, but verify with your model's parts list.

Will they improve top speed?

Lower friction can help marginally with top speed and throttle response, particularly when replacing worn steel bearings across the drivetrain.

How do I maintain them?

Keep bearings free of grit, spin them occasionally with light oil, and replace if you detect roughness or play in the races.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved