Factory Pro FP-B-CB1006 Ceramic Ball Bearing 6x10x3mm Off-Road Friendly  [FP-B-CB1006]

Price:
NZD$10.67
Brand:
Factory Pro
Model:
FP-B-CB1006
Condition:
Brand New
Write a review

Smoother Runs with Factory Pro Bearings

The Factory Pro FP-B-CB1006 Ceramic Ball Bearing is an economical way to reduce drag in your RC setup. Sized 6x10x3mm, this ceramic unit gives reliable rolling action and resists wear in common axle and wheel locations.

Why Ceramic Improves RC Performance

Ceramic balls reduce contact friction and typically retain their roundness longer than untreated steel, which means steadier performance over many runs. Upgrading to the FP-B-CB1006 can result in crisper throttle response and steadier top speed in both racing and casual use.

Compatibility Notes and Installation

This 6x10x3mm bearing fits most standard housings and requires no special adaptors. Use a gentle press fit and check alignment during installation to avoid premature failure.

Can these bearings handle dusty or muddy conditions?

Ceramic bearings resist heat and wear better than some steels, but contaminants will still shorten life. Use seals or shields and clean regularly after dirty runs.

Are they worth upgrading for a daily driver?

Yes, many hobbyists find ceramic bearings reduce maintenance and improve feel over time, making them a good choice for often-driven models.

Do I need special tools to fit the FP-B-CB1006?

A basic bearing press or a smooth, controlled drift is usually sufficient. Avoid hammering directly on the bearing inner race.

How often should I inspect these bearings?

Check them after every few runs or immediately after water or heavy dust exposure, and relube or replace if you notice roughness.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved