Factory Pro FP-B-CB1510 Ceramic Ball Bearing Set 10x15x4mm (4pcs) Club Racer Choice  [FP-B-CB1510(4)]

Price:
NZD$43.71
Brand:
Factory Pro
Model:
FP-B-CB1510(4)
Condition:
Brand New
Write a review

Refine Your RC Drivetrain with Ceramic Bearings

Upgrading bearings is a practical way to sharpen vehicle response. The Factory Pro FP-B-CB1510 bearings bring ceramic durability and steady rotation to common bearing positions on hobby vehicles.

Precision Engineering for Consistent Runs

At 10x15x4mm, these ceramic ball bearings offer lower rolling resistance than typical steel bearings. That leads to smoother wheel spin and reduced component wear over extended use.

Suitable Across Multiple RC Types

The FP-B-CB1510(4) pack is versatile for various cars and trucks, helping cut down routine maintenance while maintaining efficient drivetrain operation for both practice runs and club events.

Will these bearings improve lap times?

They can help by reducing drivetrain drag and improving consistency, which may translate to tighter lap times depending on setup and driver skill.

How should I clean these bearings after a dusty session?

Use a mild solvent and a soft brush, then dry fully before applying a small amount of oil. Avoid abrasive cleaners that could damage ceramic surfaces.

Can they handle occasional grass or rough surfaces?

They are more tolerant than some precision steel bearings, but heavy debris and water will still shorten life. Inspect and service after rough outings.

Is bearing replacement a DIY job?

Yes, removing and fitting 10x15x4mm bearings is straightforward with basic tools; use a press or careful tapping to avoid race damage.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved