Factory Pro FP-M-AC3105RD Race-Ready 7075 Red Aluminum Spacers 3x9x0.5mm (8pcs)  [FP-M-AC3105RD]

Price:
NZD$11.89
Brand:
Factory Pro
Model:
FP-M-AC3105RD
Condition:
Brand New
Write a review

Red 7075 Spacers Built for Accurate Setup

When fine adjustment counts, quality spacers make a difference. The Factory Pro FP-M-AC3105RD pieces are produced from Al. 7075 and sized at 3x9x0.5mm, finished in red and supplied in an eight pack for multiple tuning tasks.

Practical Setup Uses

These spacers are ideal for trimming suspension geometry, dialing in gear mesh, or achieving precise link spacing. Their thin profile helps you make incremental changes without compromising part fit or balance.

Suitable Models and Fitment

Intended for general RC use, these shims suit many chassis types and can be applied in differential assemblies, steering linkages or gearbox areas where exact spacing improves performance.

Will these spacers alter handling if I use several at once?

Stacking a few 0.5mm spacers can change component geometry slightly; use small steps and test between changes to judge handling impact.

Are these parts compatible with aluminium hubs and steel shafts?

They work with common metal and alloy components, but check bore and shaft clearances to ensure a secure fit without binding.

How noticeable is finish wear on these spacers?

The red finish is durable under normal use, though friction points can show wear over time; handle and install with care to minimise abrasion.

Can these spacers be used in both 1/10 and smaller scale models?

The 3x9x0.5mm dimensions make them most common in 1/10 scale and similar sizes, but always check the specific dimension needs of smaller models first.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved