Factory Pro FP-M-ACS301BK 3mm Black Shim Set (5 x 0.5/1/2/3mm)  [FP-M-ACS301BK]

Price:
NZD$11.20
Brand:
Factory Pro
Model:
FP-M-ACS301BK
Condition:
Brand New
Write a review

Precision Shim Pack for 3mm Shafts

The Factory Pro FP-M-ACS301BK kit contains 0.5mm, 1mm, 2mm and 3mm collars, five of each, finished in black. These shims are handy for trimming gaps and refining component spacing on cars, buggies and other 3mm shaft applications.

Typical Uses

Use the collars to correct sideplay, set bearing preload, or tweak drivetrain mesh. Their range of thicknesses makes it easy to experiment with small changes until the handling or fitment is right.

Why Modelers Choose These Collars

Factory Pro collars are valued for consistent sizing and a durable finish. They are useful for both casual hobbyists and those who frequently rebuild or upgrade their rigs.

Are these collars compatible with bearing assemblies?

Yes, they can be used to fine tune bearing spacing and alignment, particularly where small thickness changes improve wheel or gear mesh.

Can I stack multiple collars for custom thickness?

Stacking collars is a common approach to achieve non standard thickness. Make sure set screws are seated correctly and check for secure fit after stacking.

Will the black finish wear off with use?

A bit of finish wear can occur where collars contact shafts, but this does not usually affect function. Inspect collars during routine maintenance and replace if finish degradation coincides with loss of fit.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved