Factory Pro FP-O-AP0001 48P 33T Over Ratio Spur Gear - retro fit for T.O.P. FD Mini and Tamiya M Series  [FP-O-AP0001]

Factory Pro FP-O-AP0001 Over Ratio Spur Gear 48Pitch 33T (for T.O.P. FD Mini & Tamiya M Series)
Price:
NZD$28.61
Brand:
Factory Pro
Model:
FP-O-AP0001
Condition:
Brand New
Available in warehouse
Write a review

Upgrade Your Tamiya M Series Drivetrain

The Factory Pro FP-O-AP0001 Over Ratio Spur Gear gives Tamiya M Series owners a reliable way to refine gear engagement. This 48Pitch 33T component fits T.O.P. FD Mini and a range of M chassis, delivering consistent torque transfer with minimal fuss.

Compatibility and Tuning Advantages

Compatible with M05, M06, M07 and M08 chassis, the over ratio profile alters the vehicle's torque curve to help you tune acceleration and top speed for different track conditions.

Setup Advice and Longevity Tips

Ensure correct pinion to spur mesh during installation to prevent undue wear on teeth. Periodic inspections and light cleaning around the gear area will help maintain steady performance session after session.

Is FP-O-AP0001 appropriate for club level tuning?

Yes. The Factory Pro FP-O-AP0001 48Pitch 33T is a simple way to tweak driveline behaviour for club racing or practice runs without swapping major components.

Do I need a special pinion for this spur?

Use a pinion with matching 48 pitch specifications and set the mesh correctly. No special pinion design is required beyond correct pitch and tooth count for your desired ratio.

How often should I check the gear?

Inspect the spur and pinion after heavy sessions or if you notice unusual noise. Quick cleanups and mesh checks after each run help prevent long term damage.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved