Factory Pro FP-O-AP0008 Rear Axle Height Adapter 1/4 Bearing for Tamiya F103 104 RM01  [FP-O-AP0008]

Factory Pro FP-O-AP0008 1/4 Bearing Rear Axle Hight Adapter (for Tamiya F103, 104 & RM01 Series)
Price:
NZD$33.82
Brand:
Factory Pro
Model:
FP-O-AP0008
Condition:
Brand New
Write a review

Tune Rear Geometry on Tamiya Models

The Factory Pro FP-O-AP0008 1/4 Bearing Rear Axle Height Adapter lets you tweak the rear axle height on Tamiya F103, 104 and RM01 series machines. It is built for hobbyists who want repeatable adjustments to handling behaviour.

Compatibility Notes

This adapter is specifically matched to the Tamiya F103, 104 and RM01 series mounting points for an accurate fit. Small changes to axle height can sharpen turn-in or stabilise the rear end depending on track surface and tyres.

Installation Pointers

Install the Factory Pro adapter using a tidy bench setup and the usual toolset including hex drivers and a fine spanner. Check axle alignment after tightening to avoid asymmetrical loads on bearings.

Can I use this with modified axles?

It is intended for stock-style axles on Tamiya F103, 104 and RM01 cars. If your axle is modified, confirm dimensions before fitting to ensure correct clearance and bearing alignment.

Will this change my gear mesh?

Axle height changes are rear-end geometry adjustments and should not affect gearbox mesh, but always re-check clearances after installation to be safe.

Any maintenance after fitting?

Periodically inspect the adapter and adjacent bearings for play or wear, and re-torque mounting hardware after the first few runs to confirm stability.

Will it fit with aftermarket diff setups?

Most aftermarket diff assemblies that keep standard axle locations will be compatible, but check clearances between the adapter and any non-standard diff cases.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved