Factory Pro FP-O-DB3189 63T 189mm Low Friction Driver Belt  [FP-O-DB3189]

Price:
NZD$15.92
Brand:
Factory Pro
Model:
FP-O-DB3189
Condition:
Brand New
Write a review

Get smoother power transfer with Factory Pro FP-O-DB3189

The Factory Pro FP-O-DB3189 low friction driver belt is designed for 1/10 scale RC vehicles where consistent belt engagement matters. At 63 teeth and 189mm length, it fits common 1/10 setups and keeps drivetrain behaviour predictable.

Why this belt suits everyday use

Its low friction profile lowers resistance in the drive train, helping conserve motor effort and improve throttle consistency on a range of surfaces. It is a practical choice for club racing and weekend running.

Simple fitting tips

Before fitting, clean pulley grooves and check for misalignment. Periodic checks for wear and proper tension will extend service life and maintain smooth running.

Is the FP-O-DB3189 compatible with belt-driven 4WD kits?

Many belt-driven 4WD 1/10 kits use similar pulley spacing so this belt will often fit, but confirm your kit's required belt length and tooth count first.

Can I reuse pulleys when replacing the belt?

Yes, pulleys can usually be reused if they are not worn. Inspect for rounded teeth or nicks before refitting a new belt.

How often should I inspect the belt?

Check the belt after heavy sessions or every few runs on abrasive tracks. Early detection of wear prevents drivetrain issues.

Does this belt affect motor temperatures?

Lower friction can slightly reduce load on the motor, which may help temperatures under sustained use, but cooling and gearing remain primary factors.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved