Factory Pro FP-O-DB3228B 76T/228 Drive Belt Long Life for RX-10F 3.0  [FP-O-DB3228B]

Price:
NZD$21.78
Brand:
Factory Pro
Model:
FP-O-DB3228B
Condition:
Brand New
Write a review

Heavy duty replacement for RX-10F 3.0

The Factory Pro FP-O-DB3228B Long Life Drive Belt for RX-10F 3.0 is a 76T/228 belt made to maintain consistent torque delivery. It is aimed at hobbyists who need a reliable spare that stands up to frequent running.

Compatibility guidance

This belt suits RX-10F 3.0 pulley layouts as a direct replacement and is manufactured from wear-resistant compounds to extend service intervals. Verify pulley tooth counts and spacing before fitting to non-standard setups.

Tensioning and care

Apply correct tension to prevent slipping and perform a short test run then re-check alignment. Replace the belt if you notice tooth deformation or a loss of tension to protect the rest of the drivetrain.

Will this belt work with other RX series cars?

The FP-O-DB3228B is specified for RX-10F 3.0 geometry. Other RX series cars may use different pulley sizes or belt lengths, so confirm specifications before installing on a different model.

Is there a break-in needed for this belt?

A brief running period with progressive load helps seating and tension stability. After that, re-check and fine-tune tension to avoid early slippage.

Which running surfaces suit this belt?

The belt performs well across common surfaces used by hobbyists, from smooth indoor tracks to typical outdoor layouts, as long as sprocket alignment and tension are maintained.

How should I store spare belts?

Keep belts flat in a cool, dry place away from direct sunlight and solvents. Avoid sharp bends or heavy loads on stored belts to prevent deformation.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved