Factory Pro FP-O-DB3351 Low Friction 117 Tooth Drive Belt 351mm  [FP-O-DB3351]

Factory Pro FP-O-DB3351 Low Fraction Driver Belt 117T/351
Price:
NZD$18.00
Brand:
Factory Pro
Model:
FP-O-DB3351
Condition:
Brand New
Write a review

Factory Pro FP-O-DB3351 Drive Belt for Smooth Power

The Factory Pro FP-O-DB3351 Low Fraction Driver Belt is built to deliver dependable, low-resistance belt drive operation for RC kits and custom rigs. Its 117-tooth count and 351mm loop suit many 1/10 scale belt drive systems.

Less Friction, Cleaner Power Flow

Designed to reduce energy loss in the drivetrain, this belt helps maintain consistent throttle response and reduces heat buildup from wasted motion. It is a practical upgrade for extended practice sessions.

Broad Compatibility with Belt Drivelines

The FP-O-DB3351 fits a wide range of common 1/10 arrangements and usually installs without major chassis changes. Its standard dimensions mean quick replacements at the bench between sessions.

What tension should I set for this belt?

Aim for a firm but not tight tension so the belt tracks true without binding; check your chassis manual or use a simple deflection test across the longest span.

Can I run this belt on modified motor setups?

Yes, provided pulleys and layout suit the 117T/351 loop and you adjust tension and cooling for higher output motors to avoid premature wear.

How should I clean or maintain the belt?

Wipe it with a dry cloth to remove grit and inspect teeth for nicks. Avoid solvents that can degrade the compound and recheck alignment after cleaning.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved