Factory Pro FP-O-DB3513 Smooth Drive Belt 171T 513mm  [FP-O-DB3513]

Price:
NZD$19.27
Brand:
Factory Pro
Model:
FP-O-DB3513
Condition:
Brand New
Write a review

Smoother drivetrain with Factory Pro FP-O-DB3513

The Factory Pro FP-O-DB3513 Low Friction Driver Belt gives hobbyists a reliable way to lower drivetrain resistance. Featuring 171 teeth and a 513mm span, it helps maintain steady power transfer under typical running conditions.

Where this belt fits

The belt suits a variety of RC machines that call for a 171T/513mm drive belt. Its low friction design makes it versatile for both competition and everyday park running, fitting many common chassis arrangements.

Installation pointers and longevity

Install the FP-O-DB3513 by lining up the belt with the pulleys and setting even tension to prevent uneven wear. Regular inspections for tooth damage and correct alignment will extend service life and keep performance consistent.

Can I replace my existing belt with the FP-O-DB3513?

You can swap in the FP-O-DB3513 if your current belt is 171T/513mm. Measure pulley centers and tooth count to make sure the fit is correct.

How should I store spare belts?

Keep spare belts flat in a cool, dry place away from direct sunlight and chemicals to avoid deformation and preserve flexibility.

Are there special checks after fitting?

After fitting, run the model at low speed to check alignment and listen for rubbing or skipping, then recheck tension after the first short run.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved