Schumacher Mi9 Factory Pro O-SCP023 Graphite Steering Plates  [FP-O-SCP023]

Price:
NZD$37.38
Brand:
Factory Pro
Model:
FP-O-SCP023
Condition:
Brand New
Write a review

Performance Graphite Steering Plates for Schumacher Mi9

If you want a straightforward way to up your handling, the Factory Pro O-SCP023 hub plates are a practical choice. Specifically made for the Schumacher Mi9, the set includes four precision-cut graphite plates for front left, front right, rear left and rear right. The graphite construction boosts longevity while keeping the assembly light for better response.

Strength Without Extra Weight

Graphite brings strong structural properties without the weight penalty of some metals. That helps keep the car nimble and responsive on technical sections. Each plate is produced for a snug fit so steering inputs remain accurate on the Schumacher Mi9.

Suited to Club and Touring Races

These plates are aimed at pilots who want improved steering consistency without a heavy investment. Replacing stock hub plates can reduce steering vagueness and improve lap-to-lap repeatability.

Can I reuse my existing hardware?

In most cases stock screws and spacers can be reused, but inspect for wear and replace any damaged fasteners for a secure fit.

Will graphite change the car balance?

Graphite is lighter than some metals so the change is small; you may notice a slightly crisper steering response rather than a major balance shift.

Are these plates fragile?

Graphite used here is engineered for RC use and offers good toughness, but like any material it will wear or crack under severe impact; avoid heavy collisions to prolong life.

Do these require setup changes?

Most setups remain unchanged, though you should check steering geometry after fitting to ensure toe and camber are within your preferred tolerances.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved