Factory Pro FP-O-TCP006 Tamiya TRF421 Front Brace Pair 1mm and 2mm  [FP-O-TCP006]

Factory Pro FP-O-TCP006 Tamiya TRF421 - Front Bulkhead Brace Set (1&2mm Each 1pc)
Price:
NZD$13.87
Brand:
Factory Pro
Model:
FP-O-TCP006
Condition:
Brand New
Write a review

Limit Chassis Movement on the TRF421

The Factory Pro FP-O-TCP006 set provides a matched 1mm and 2mm brace to reinforce the front bulkhead of a Tamiya TRF421. Fitting these reduces unwanted flex where the chassis wants it least.

Cleaner Turn-In and Balance

By tightening the front section, the car responds with firmer turn-in and more predictable balance under braking, making setup changes more obvious on different surfaces.

Bolt-On Upgrade With Minimal Work

The braces are shaped to suit the TRF421 layout and typically install without major trimming, letting drivers add stiffness during a routine maintenance session.

Can I fit only one brace for a milder effect?

Yes, installing just the 1mm or just the 2mm brace will give different levels of stiffness so you can test which suits your driving style.

Will these change my ride height or camber?

The intention is to reduce front flex rather than alter geometry, but you should recheck ride height and camber after fitting to confirm your setup.

Do I need special screws to fit them?

Most installs use the existing front bulkhead hardware; having a selection of small drivers and a torque tool helps ensure a neat fit.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved