Yokomo BD12 Factory Pro O-YCP015 Graphite Chassis Plate  [FP-O-YCP015]

Price:
NZD$78.91
Brand:
Factory Pro
Model:
FP-O-YCP015
Condition:
Brand New
Write a review

High-Grade Graphite Chassis for Improved Track Response

Upgrade your Yokomo BD12 with the Factory Pro O-YCP015 main chassis to gain a stiffer central platform. Made from quality graphite and finished flat-matt, the 2.25mm thickness helps stabilise the car under braking and cornering forces.

Advantages of Using Graphite

Graphite offers a favourable stiffness-to-weight ratio, so the Factory Pro O-YCP015 trims unnecessary mass while increasing precision. That makes setup changes more effective and helps the car feel more consistent lap after lap.

Installation and Setup Advice

Fit the Factory Pro O-YCP015 by aligning every mounting point and tightening screws progressively. Apply thread lock to metal fasteners and confirm there is no unwanted movement after an initial shakedown.

Will adding this chassis change my BD12 balance?

The Factory Pro O-YCP015 shifts stiffness towards the centre, which can alter handling balance. Expect subtle changes and tune shock and camber settings as needed.

Is special hardware required to fit it?

The chassis uses standard BD12 mounting points. Keep your original hardware handy, and have thread lock available for metal screws to prevent loosening.

Can I sand or trim the chassis if I need clearance?

Minor trimming is possible but should be done carefully to avoid weakening load-bearing areas. Test-fit before finalising any cuts.

How does the 2.25mm thickness influence tuning?

A thicker chassis increases overall stiffness, which can make the car more responsive to steering inputs but may require suspension softening to maintain grip on bumpy surfaces.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved