Factory Pro M-AC3050OG Orange Gold 3mm x 5.0t Collar Kit [FP-M-AC3050OG]

Price:

NZD$5.03

Brand:

Factory Pro

Model:

FP-M-AC3050OG

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the

R/C General - Shim / Washer

Accurate Collar Control with Factory Pro M-AC3050OG

When you need tight tolerances during setup, the Factory Pro M-AC3050OG 3mm x 5.0t collars make alignment tasks easier. The orange gold finish gives a clean appearance while the collars help lock parts in place for consistent handling and maintenance checks.

What parts are these collars meant for?

They are typically used on 3mm shafts to act as spacers or stops on axles, pushrods and other rotating or sliding parts.

Do they require special tools to fit?

No special tools are needed; small hex keys for the grub screws and soft-jawed pliers are usually sufficient for a secure, scratch-free install.

Are there maintenance considerations?

Periodically check set screw tightness and inspect the collar seating to prevent wear or movement under load.

Can I use them on aluminium or steel shafts?

Yes, they work on common shaft materials but take care with tightening to avoid deforming softer shafts; verify compatibility for your specific setup.

Hot Brands