Factory Pro O-SPP007F Graphite Front Lower Suspension Arm for Serpent Medius X26  [FP-O-SPP007F]

Price:
NZD$18.95
Brand:
Factory Pro
Model:
FP-O-SPP007F
Condition:
Brand New
Write a review

Lower Arm Details

Designed as an RC front lower arm for the Serpent Medius X26, the Factory Pro O-SPP007F is a single-piece graphite component aimed at helping you dial in suspension behavior. It replaces the Medius X26 front lower arm as an aftermarket tuning part rather than a cosmetic upgrade.

Compared with standard composite arms, the graphite construction increases axle rigidity and can produce firmer steering feedback when adjusting camber and roll. Use this arm to modify front-end characteristics at the model level.

Fitting is a straight swap into the front lower arm position of the Medius X26 chassis; confirm alignment and handling after installation. Supplied as one pcs.

Do I need additional parts to install this arm?

No extra parts are normally required. The O-SPP007F is designed to mount in the same position as the original Medius X26 front lower arm.

Is the arm made from real graphite?

Yes, this component is manufactured as a single graphite piece to increase stiffness compared with common composites.

Can I use it to change camber settings?

Yes. The part is intended to support adjustments to camber and roll during setup, allowing finer tuning of front geometry.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved