FANTOM 26mm rotor sensor board FA-19219 for HELIX and ICON - Yokomo  [FA-19219]

FANTOM sensor board fitting and notes

This replacement sensor board is designed for the FANTOM motor lineup and fits motors built for a 26mm rotor. It supplies the necessary sensor interface for sensored operation when paired with HELIX, HELIX V2, ICON V2, ICON V3 and ICON-Torque motor types. The component restores electronic position feedback and does not change the motor's mechanical build.

When installing, ensure the board variant matches the specific motor model and align connector pins precisely with the motor harness. Double-check connector type and part orientation before powering the system. As this is a component-level swap, inspect connectors and solder joints on both the motor and ESC, and use ESD precautions to protect the new board.

The sensor board does not modify power delivery or timing settings itself; it simply provides the rotor position signals required by sensored ESC setups. If issues continue post-install, check ESC sensor configuration and motor timing rather than assuming a mechanical failure.

Replace a malfunctioning sensor module with the Yokomo FA-19219 to restore accurate rotor position feedback in sensored FANTOM setups; follow up with a sensor verification routine and ESC menu checks.