This anodized blue aluminum center shaft cup joint is manufactured as a direct metal upgrade for the Kyosho Fazer Mk2 FZ02 driveline. It is intended to replace the original plastic cup to deliver a more stable connection between the center shaft and driveshaft, improving repeatability over long sessions.
Constructed from anodized aluminum, the component focuses on wear resistance and consistent mating geometry so that driveline straightness is easier to maintain under heavy use. It is commonly fitted when worn parts are discovered during inspections or when upgrading to metal components for more predictable service life.
Installation follows standard on-road center drive procedures: remove the center driveshaft assembly, inspect mating surfaces and bearings, transfer or replace retaining hardware as required, and fit the new cup ensuring proper alignment and free movement before final tightening. Verify the assembly runs true after refit.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
