Kyosho Fazer Mk2 FZ02 Aluminum Center Cup Joint Upgrade JR-KFZ201-RD by Jazrider  [JR-KFZ201-RD]

Kyosho Fazer Mk2 FZ02 Aluminum Center Shaft Cup Joint (Red)
Price:
NZD$11.00
Brand:
JAZRIDER
Model:
JR-KFZ201-RD
Condition:
Brand New
Available in shop
Write a review

Replacement center cup for Fazer Mk2 FZ02

This aluminum center shaft cup joint serves as an upgrade replacement for the Kyosho Fazer Mk2 FZ02, intended to swap in for worn plastic or standard metal cups. It enhances the center driveline connection and increases resistance to wear without altering the vehicle's stock geometry.

Installation notes: remove the center shaft, fit the cup joint onto the shaft end while ensuring spline engagement, then reassemble and verify free rotation. Typical RC hand tools are adequate; take care not to compress bearings or over-torque fasteners to avoid driveline binding.

Use case for setup: install this component to address driveline looseness or to stabilise handling during tuning sessions. The aluminium body gives consistent wear patterns, making it a good choice for ongoing maintenance and incremental handling adjustments on the Fazer Mk2 FZ02.

How do I replace the center cup on my FZ02?

Strip the center shaft assembly, remove the old cup, slide the new aluminium joint onto the shaft ensuring splines align, then rebuild in reverse order while checking runs free.

Do I need to shim bearings after installation?

Check shaft endplay and bearing seating after fitting. Minor shimming may be required to maintain correct clearance, depending on your chassis condition.

Can I reuse the original hardware?

Original retaining hardware is usually reusable if undamaged; inspect screws and pins for wear and replace any compromised parts to ensure secure fitment.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved