Kyosho Fazer Mk2 FZ02 Compatible Front/Rear Wheel Shafts JR-KFZ202-LB by Jazrider  [JR-KFZ202-LB]

Kyosho Fazer Mk2 FZ02 Aluminum Front/Rear Wheel Shaft (Blue,2pcs)
Price:
NZD$9.57
Brand:
JAZRIDER
Model:
JR-KFZ202-LB
Condition:
Brand New
Available in shop
Write a review

Overview: Fazer Mk2 FZ02 wheel shaft kit

This kit provides front and rear wheel shafts for the KYOSHO Fazer Mk2 FZ02 chassis, delivered as two aluminum shafts in blue. They serve as metal replacements for standard shafts and are intended to reduce flex and improve repeatable wheel positioning compared with lower-grade components.

Use these shafts where wheel retention and precise lateral clearance are important to handling. This is a direct chassis replacement; confirm the FZ02 designation on your Fazer Mk2 to guarantee compatibility with the design referenced in the title.

Fitting is accessible for hobbyists: remove wheel and hub, swap the existing shaft for the replacement, then reassemble, checking bearing alignment and wheel runout. Use appropriate hex tools and avoid excessive torque on fasteners to prevent bearing preload or hub damage. Perform routine inspections after first use.

Does this replace both front and rear shafts?

Yes, the set includes shafts intended for both front and rear mounting positions on vehicles that use the FZ02 layout.

Are additional parts required for installation?

No extra parts are normally required; reuse the original hubs and bearings where they are in good condition. Replace worn bearings if needed for best results.

What care prevents corrosion?

Wipe shafts clean after wet use, inspect for surface wear, and keep fasteners appropriately torqued. The anodized finish adds corrosion resistance but does not make them maintenance free.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved