FF03 Front Suspension Mount Aluminium 1F TAMIYA 415-01/1F/V2 by 3Racing  [415-01/1F/V2]

Tamiya TRF 415 FF03 TA-05IFS TRF-416 Option Aluminium Suspension Mount (1F) - Ver. 2 - 3RACING 415-01/1F/V2
Price:
NZD$8.38
Brand:
3Racing
Model:
415-01/1F/V2
Condition:
Brand New
Write a review

1F Front Mount Technical Summary

This machined aluminium front suspension mount is the Ver. 2 replacement part named and sized as in the title. It is designed for the 1F front mounting location and offers greater local stiffness than typical plastic mounts.

Intended compatibility includes TRF 415, FF03, TA-05IFS and TRF-416. Before fitting, verify that your chassis uses the same 1F mounting geometry listed here.

Fitting is a direct swap: remove the factory mount, move over any bearings or inserts, then attach this aluminium mount with the original screws where possible. Check thread engagement and proper screw length to avoid damaging parts.

Tuning note: an aluminium 1F mount reduces compliance at the mount point, which can make steering quicker and more precise. Consider this as part of a broader setup change and validate handling on a controlled run.

What checks should I do before installation?

Confirm hole spacing and mounting boss height at the 1F location, and make sure the steering arms and shocks clear the new mount. If unsure, compare against a donor TRF 415 or FF03 chassis.

Will bearings or bushings transfer over?

Yes, any bearings or inserts from the stock mount are normally transferred to the aluminium piece. Inspect each item for wear before reuse.

Is any chassis modification required?

No major modifications are expected if your chassis matches the listed models, but minor clearance checks and fastener swaps may be needed. Do not force mismatched screws into aluminium threads.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved