For Blitzer Beetle JR-TASB04-DB Dark Blue Aluminium Rear Knuckle Arms compatible with Stadium Blitzer and Stadium Thunder by Jazrider  [JR-TASB04-DB]

Aluminum Rear Knuckle Arms (Dark Blue) For Blitzer Beetle / Stadium Blitzer / Stadium Thunder
Price:
NZD$18.84
Brand:
JAZRIDER
Model:
JR-TASB04-DB
Condition:
Brand New
Available in shop
Write a review

Aluminium Rear Knuckles Built for Blitzer Beetle Chassis

The JR-TASB04-DB set provides a pair of aluminium rear knuckle arms intended for Blitzer Beetle models and their stadium-series siblings. Each arm is machined from aluminum and given a dark blue anodized finish to resist surface wear from handling and track use. These are offered as a robust hop-up to replace the original plastic knuckles and reduce unwanted flex in the rear linkage.

Fitment applies to vehicles sharing the same rear hub spacing and mounting layouts as the Blitzer Beetle and its stadium counterparts. Confirm your chassis uses the same pivot and wheel hex arrangement before purchase to ensure proper fit. Note that the kit is a small parts upgrade and does not ship with bearings, pins, or mounting screws.

Installation guidance: follow your chassis manual to remove the rear hub assembly, transfer any existing bearings or inserts into the new knuckles where required, and secure them with the original hardware. Verify full travel and ensure there is no binding at suspension extremes. A small amount of thread locker can be applied to metal fasteners for vibration resistance, but avoid excessive torque to maintain pivot freedom.

Tuning impact: replacing plastic knuckles with aluminum reduces compliance, which can help maintain rear toe and camber under cornering loads and give a more consistent handling response. Integrate these arms into a balanced setup alongside suitable shock rates and tyre choices for best results.

Compatibility

  • Fits: Blitzer Beetle
  • Fits: Stadium Blitzer
  • Fits: Stadium Thunder
Yes. The product is sold as a matched pair covering both left and right rear knuckle arms for a single axle.
Typically you can reuse the original fasteners and bearings unless they show wear or do not match the new knuckle dimensions; replace only if necessary.
Because these arms reduce component flex, expect firmer rear-end behaviour and improved repeatability when the vehicle is driven aggressively; tune shocks and tyres accordingly.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved