For SRB Rotor Heads Wash-Out Link HI0302006 Hirobo  [HI0302006]

HIROBO 0302-006 SRB WASH-OUT ASSEMBLY #0302006
Price:
NZD$10.48
Brand:
Hirobo
Model:
HI0302006
GTIN:
4512895149949
Condition:
Brand New
Write a review

Wash-Out Link for SRB Rotor Heads

This wash-out link is an SRB-category replacement intended to slot into SRB rotor head wash-out systems. It is supplied as a service-style linkage to help set and hold wash-out and collective geometry while you work on blade tracking and control response.

Fitment is restricted to SRB parts; check the physical interfaces on your rotor head before installation. The component attaches to existing SRB wash-out anchor points and is intended for part replacement during routine servicing or repairs.

When tuning, treat the link as a precision trim item: adjust its position and the servo travel endpoints to re-establish correct wash-out, then validate collective pitch and cyclic behaviour in a controlled hover assessment.

Can I use this with other rotor head types?

This unit is tailored for SRB category geometry. It may not line up with non-SRB heads; verify hole spacing and linkage lengths before fitting to avoid binding or improper geometry.

What is the recommended installation sequence?

Remove the old linkage, position the new wash-out link while the rotor is at neutral, secure fasteners hand tight, then set servo endpoints and final torque. Confirm free movement through the full pitch range before flight.

Any tips for balancing blade tracking after replacement?

Start with blades level and rotor neutral, then adjust the new link and servo trims incrementally while watching tracking markers. Minor adjustments followed by short hover checks yield the most reliable results.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved