For Tamiya TA-01: Aluminum Rear Suspension Arms (Red) - JR-TA111-RD by Jazrider  [JR-TA111-RD]

Price:
NZD$17.93
Brand:
JAZRIDER
Model:
JR-TA111-RD
Condition:
Brand New
Available in shop
Write a review

TA-01 rear arm upgrade

This RC rear suspension arm set is tailored for the Tamiya TA-01 chassis and comes in red-anodised aluminium. The parts offer a metal substitute for the original plastic arms, aimed at hobbyists who want a firmer rear and more repeatable handling.

Fitment is specific to TA-01 geometry. The arms are supplied as direct replacements and are designed to use the existing pivot points and hardware on the TA-01; check ball studs, hinge pins and bushings during assembly to ensure proper alignment and free movement.

In tuning terms these alloy arms increase lateral rigidity versus standard plastic pieces, which can change how the chassis transfers loads in corners. Combine them with spring and damper adjustments plus anti-roll bar and toe setup changes to refine handling.

Anodising provides a hard surface layer that helps protect the alloy from light abrasion and corrosion; it improves cosmetic longevity but inspect areas around pivot points regularly for wear.
Because aluminium transfers load differently, check hinge pins and bushings more frequently after installation and replace any worn hardware to maintain smooth operation.
Aluminium offers greater stiffness than plastic and resists flex, but in severe impacts metal can deform; inspect components after crashes and replace if any bend or crack is detected.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved