For TRAXXAS 1/18 LaTrax SST Aluminium Brake Disk Hex Adaptors 12mmx6.5mm SST010A/DISK by GPM  [SST010A/DISK]

Precision hex adaptors for LaTrax SST

This pair of aluminium hex adaptors is made for use on TRAXXAS 1/18 LaTrax SST models, providing a straightforward replacement for the wheel hub to brake disk junction. The two-piece set follows the 12mmx6.5mm dimensions noted in the title and is built for RC use.

Use and setup: the adaptors maintain the wheel hex to disk interface, offering improved stiffness over stock plastic components when tuning wheel seating or correcting minor runout. They are well suited to regular maintenance cycles and handling adjustments.

Installation tips: check compatibility with your LaTrax SST hubs before fitting, measure the 12mmx6.5mm interface on your components, and make sure each adaptor is seated fully. Inspect fit after the first few runs to ensure proper alignment and to spot any early wear.

Construction notes: constructed from aluminium for enhanced rigidity, these adaptors help keep the brake disk and wheel hub concentric under load. They are intended only for scale RC applications.