TRAXXAS 1/10 Carbon Steel 86T Spur Gear SSLA2W086T by GPM  [SSLA2W086T]

Heavy Duty 86T Spur for TRAXXAS 1/10 48P Systems

This 86-tooth carbon steel spur is supplied as an aftermarket replacement for compatible TRAXXAS 1/10 2WD machines shown below. Manufactured from hardened carbon steel and precision machined for a 48P tooth profile, it provides a metal alternative to the OEM nylon spur for rear gearbox power transfer.

Installation suits any modeller familiar with TRAXXAS drivetrain servicing. Remove the gearbox cover at the rear, note the existing shims and gear mesh, swap in the 86T steel spur and use the included stainless shim washers to fine-tune engagement. Re-torque all fasteners to the recommended values and verify free-spinning driveline operation before use.

Tuning guidance: moving from nylon to steel changes wear patterns on the pinion and bearings, so inspect mating parts more frequently. Confirm your pinion tooth count and pitch match the 48P spur and set proper mesh to reduce risk of premature wear. This component is intended for scale RC drivetrain use only and should be installed on compatible chassis.

Use this steel spur when you want a stiffer gearbox option; replace any worn mating components and check gear mesh after fitting for reliable operation.