Freya Elevator Lever Shaft R - Hirobo HI0414131  [HI0414131]

Elevator lever R specifications

This right-side elevator lever shaft R serves as a direct replacement for the Hirobo Freya range and is supplied as a single component to re-establish proper elevator linkage geometry at the tail assembly. It is intended for use as an accessory part for control linkage maintenance and repair on RC helicopters.

Installation notes: verify the correct right-hand orientation before installation, clear out any damaged fasteners and check the mating lever for excessive play, slide the new shaft into the lever bore ensuring smooth pivot action, secure the retaining hardware and confirm the elevator moves through its full range without binding. Perform ground checks at low throttle settings to ensure neutral alignment and reliable control response.

Tuning impact: fitting a straight, unworn elevator lever shaft reduces linkage play and helps recover crisp elevator response, aiding trim stability and cyclic balance when troubleshooting persistent input slop.