Front Hub Carrier Right 18deg for MP11 - IF710-R Kyosho  [KY-IF710-R]

Kyosho IF710-R - Front Hub Carrier (R/18deg/MP11)
Price:
NZD$97.53
Brand:
Kyosho
Model:
KY-IF710-R
GTIN:
4548565518876
Condition:
Brand New
Write a review

MP11 right front carrier, 18 degrees

The Kyosho IF710-R serves as the right-side front hub carrier for the MP11 chassis and is set to an 18deg steering orientation. It acts as the wheel spindle mounting point and is intended as a correct-fit replacement for the MP11 hub unit.

Choose this carrier to restore original steering geometry or to replace a unit that has been compromised by crashes. By keeping the 18deg right-side setting, it helps maintain toe and caster relationships expected for MP11 setups. For RC-scale maintenance and tuning only.

Installation advice: confirm the carrier seats correctly on the MP11 upright, and check adjacent components like bearings and hex screws for signs of wear. After assembly, verify wheel alignment and steering movement before full-speed use.

Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.
Yes. When the original carrier is bent or shows wear from impacts, replacing it with the IF710-R restores the intended MP11 right-side geometry.
Over time, damage or play can alter steering geometry. Replacing a worn carrier with a correctly spec'd IF710-R helps return handling to factory-aligned expectations.
You can reuse hardware if it is in good condition, but inspect bearings and fasteners closely and replace any parts that show wear to avoid premature failure or misalignment.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved