Front Mono Absorber for Auper D6 SAK-D6807C/PU - Purple by 3Racing  [SAK-D6807C/PU]

Price:
NZD$23.12
Brand:
3Racing
Model:
SAK-D6807C/PU
Condition:
Brand New
Write a review

Single-shock front unit for tuning

This front mono absorber is made for RC use on the Auper D6 chassis, offering a single-shock option for the front end. The purple finish identifies the unit as a direct hop-up or replacement for Auper D6 mono configurations.

Fitment utilises the Auper D6 front shock mount points and standard mounting hardware; when positioned on the correct mounts the unit replaces the stock front mono absorber while integrating with existing suspension link geometry.

From a tuning perspective, the mono absorber centralises damping and alters how the front end transfers load. Tuning is normally approached by adjusting spring selection and shock oil in measured steps to influence balance, turn-in, and overall grip.

What initial spring and oil choices should I try with the mono absorber?

Start conservatively: use a spring and a medium-weight shock oil comparable to your stock setup and make small increments. Observe changes to front-end balance before moving to more extreme rates.

How will this change turn-in and traction on the Auper D6?

The single absorber tends to centralise damping, which can sharpen or soften turn-in depending on spring and oil choices. Fine-tuning those elements will determine how much grip and responsiveness you gain.

Can I use my existing front links and sway components with this unit?

Yes. The unit is designed to integrate with the Auper D6 front suspension links, though it is prudent to check clearances and linkage angles after installation.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved