Supplied as a two-piece set, these front outer suspension pins are intended for 1/10 electric touring car applications and replace the outer pivot pin on the front suspension arm. Use them for model-level maintenance and setup on compatible Yokomo YZ-2 and B-MAX2 chassis variants.
When fitted, the pins retain the outer pivot point of the front arm and influence roll behaviour and steering feel compared with worn hardware. Inspect fit and ensure smooth articulation before tightening fasteners to maintain correct suspension geometry.
Fitting guidance: remove the wheel and front arm for clear access, clean mounting surfaces of grit or old lubricant, and recheck for play after installation. These parts are intended as service replacements rather than a standalone upgrade.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved