Front Shock Tower for Tamiya TA01 and TA02 JR-TA106-RD by Jazrider  [JR-TA106-RD]

Tamiya TA01 / TA02 Aluminum Front Shock Tower (Red)
Price:
NZD$16.71
Brand:
JAZRIDER
Model:
JR-TA106-RD
Condition:
Brand New
Available in shop
3 Reviews
Write a review

Durable anodized tower built for TA01 and TA02 use

The JR-TA106-RD is an aluminum front shock tower crafted for Tamiya TA01 and TA02 platforms, supplied in a red anodized finish that resists wear and corrosion. It replaces the stock plastic tower to provide a firmer shock mounting location and longer service life.

Fitting is straightforward for racers and club drivers: remove the plastic tower, move across any spacers or inserts, align the replacement with the front suspension points, and refit using the original screws. Inspect clearance around the steering linkage and shocks before final tightening.

From a durability standpoint the aluminum tower reduces deformation under load and helps maintain consistent setup readings over time. Combine the JR-TA106-RD with quality shock components to keep front-end behavior predictable across multiple runs.

 

Product Reviews
3 Reviews
rating
Fast delivery, great comms, smooth and painless transaction, always a pleasure.
rating
Great service, very quick, loads of parts
rating
great to deal with and communication is very good !👍

How does the anodized surface hold up on road cars?

The anodized coating improves surface hardness and corrosion resistance, helping the tower withstand routine track wear and exposure to damp conditions better than plain aluminum.

Will the aluminum tower outlast the stock plastic part?

Yes, aluminum is significantly more resistant to impact and fatigue than molded plastic, so you should see longer service life under similar use.

Any special care to preserve the finish?

Clean with mild detergent and water after salty or muddy runs, and avoid abrasive cleaners to keep the anodized surface looking and performing its best.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved