Front Anti-Roll Block Right for R12 (Right Mount) - Yokomo R12-17R  [R12-17R]

Yokomo R12-17R Front Stabilizer Block Right for R12
Price:
NZD$8.33
Brand:
Yokomo
Model:
R12-17R
GTIN:
3888
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - R12 category
Write a review

Front anti-roll block, right mount for R12

This part is an authentic right-side front stabilizer block manufactured for the Yokomo R12 range. It is supplied as the right-hand unit and works as a direct replacement or option where the R12 design uses separate stabilizer blocks, including GT-series option configurations referenced below.

Role in setup: the block sets the stabilizer link position and modifies front roll resistance. Swapping the right block changes preload and the effective stabilizer geometry, enabling subtle tuning of front-end response and balance during cornering. Install this component when tuning roll distribution or when replacing a worn right-side mounting point.

Fitting tips: mount the unit in the same location as the original block to maintain link alignment. Some front-end disassembly is normally required for replacement; ensure correct orientation and secure hardware to recommended settings. No additional hardware is supplied.

Compatibility

  • GT5-R35
  • GT5-SC430
  • GT3-REA
  • GT3-IS350
  • GT3-B4
  • GT3-CAX
  • GT3-BRZ
  • GT3-AHP
  • GT-B
  • GT5-R2
  • GT5-RS2
  • YR-R12C3
  • YR-R12C31
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What tuning changes can I expect from this block?

Expect modest changes to front roll stiffness and transient behaviour; adjustments mainly influence how the front end resists roll and can help dial in turn-in characteristics.

Is this part durable for frequent track use?

Yes, when installed correctly this genuine block is built to endure normal racing and practice use; inspect for wear after heavy impacts and replace if mounting faces or link pivots show damage.

Do I need to change stabilizer links when fitting?

Usually the existing links can be reused, but verify link lengths and alignment after installing the new block to ensure correct geometry and preload.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved